Glitter

Black
Description: 

Available in 3 sizes Pin Head, Slither and Hex

Smallest quantity available is 50 grams which would cover approximately 100 square metres of floor space.

Can be blended together if requested.

Data Sheets

 

 

Disclaimer

The colours displayed on this website are photographed to represent products as accurately as possible, however limitations of computer screens/monitors can affect the colour tones and sizes. It is strongly recommended to cross check the chosen colour against a Designer Flake hard sample of the same colour prior to ordering, as there is a strict “No Return Policy” in place. (Note: the use of different types of coatings used will also effect colour tones)
Designer Flake does not warrant or represent the accuracy, currency or completeness of information or material available on its website. Designer Flake reserves the right to change information or material on the website at any time without notice, including but not limited to details relating to products offered, product colours, product sizes, technical information, fees or services. It is the user’s responsibility to consult directly with Designer Flake to confirm the accuracy, currency and completeness of information, particularly before acting in reliance upon such information. Web links from this site to external websites should not be construed as implying any relationship with and/or endorsement of the external site or its content by Designer Flake, nor any commercial or other relationship with other owners of such sites.


Product Warranty


Designer Flake Pty Ltd has no control over the use or storage of products and therefore does not accept liability in this regard. Any verbal advice given should not be regarded as authoritative information. This information is subject to change without notice, all suppliers and applicators should ensure they have current information. Flake products are intended for use by skilled and where applicable licensed trades people. Flake products are warranted to be of uniform quality within the Manufacturers tolerance. The Manufacturer has no control over the use or misuse of its product, therefore no warranty rests or implied is or can be made either as to the effects of such use. The Manufacturers obligations shall be limited to replacing product proving to be defective.

 

Designer Flake Pty Ltd. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Designer Flakes directions and tested in accordance with Australian and Designer Flake standards. Designer Flake’s liability is limited to replacement of material found defective. As Designer Flake Pty Ltd. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.