 |
|
|
||||||
|
||||||||
|
|
|
|
|
|
|
pH: (07) 5597 1949 Fax: (07) 5597 5733 8/42 Dominion Road Ashmore Queensland 4214 |
|||||
|
|
|
Welcome to the Frequently Asked Questions (FAQ page). Below, we have tried to answer the most common questions visitors to this our Web site may have. If you find that your question is not answered on this page, please E-mail us sales@designerflake.com or call us during [BUSINESS HOURS] at (07) 5597 1949. How much does this system cost? What is the system made up of? How thick is the finished product? What advantages are there to using this system? Who would use these products and systems? Is it a safety floor/non-slip? How long does it take to apply the total system? Why does it take so long to apply? Where would I use it domestically? Is there facillities for Do It Yourself? . How much does this system cost? . A. Depending on the required preparation, and meterage of area/s to be coated. . What is the system made up of? A. Solvent free epoxies and acrylic flakes and UV protective non-yellowing finishing coats. . How thick is the finished product? A. No more than up to 2.5 mm thick so example four coats of a good quality paint. . What advantages are there to using this system? A. Long lasting/decorative/low maintenance cleaning/will not harbor bacteria/ antistatic seamless/wont crack/chip or peel/competitve in price to a lot of surface coatings or tiles/ linoleums/vynals. . Where is it used or applied? A. Any flat surface either ceiling/walls/floors after preparation . . Who would use these products and systems? A. Hotels Hospitals Schools/colleges/universities Butcher shops Food preparation areas Aged care facilities Clubs/sporting/RSL's Shopping Malls/Centres Councils State Government Institutions . Is it a safety floor/non-slip? A. Yes in cases where the surface is required to have a non-slip surface, additives are included to Australian Standard readings for this purpose. Also our Stone- Grip system, is a totally non-slip system and has been successfully applied internally and externally. . How long does it take to apply the total system? A. Depending on the preparation time, approximately three to four days. The system must be traffic free (foot) for no less than twenty four hours after final coat, and, 5 to 7 days of vehicular traffic depending on weather conditions. . Why does it take so long to apply? A. This is a total epoxy system which requires time to cure under normal weather conditions. This is to ensure that the curation of the total system is good and that it will do what is said, and due care by the customer will only enhance its life span. A. Very ~~ mild detergents and warm water is usually enough to clean this system. Mops are not recommended for use as they leave a "dirty film" over the surface. Sponge mops or stiff brooms and water or cleaning machines are all recommended. A. This floor system is very strong. Trucks/four wheels drives/fork lifts/ etc. run over the surfaces with ease and do not damage at all. . Where would I use it domestically? A. The areas are infinitesimal! Some examples are; . Patio’s Around swimming pools driveways garages any area outside you would like dressed up. . Internally throughout the whole home on floors/walls showers toilets bathrooms laundries rumpus rooms bench tops renewing that old kitchen laminex bench These are some of the areas the system has been successfully applied to already. Special requirements> . This system is good where families have children or adults with Asthma etc. or allergies to things like carpets and mites in such products. Q. Is there facillities for Do It Yourself? A. Yes full DIY application sheets are available at designer flake, upon request.
|
|
|